Stamina 1764 Owner's Manual page 9

ASSEMBLY INSTRUCTIONS
STEP 6
There is an "L" decal on the LEFT PEDAL LINKAGE(4), and an "R" decal on the RIGHT PEDAL
LINKAGE(5). Refer to the RIGHT PEDAL ARM ASSEMBLY view for the following assembly:
A. Attach a PEDAL ARM(3) to the RIGHT PEDAL LINKAGE(5) with the SUPPORT PLATE(83), WAVE
WASHER(ø20xø26x0.5mm thick)(84), and BUTTON HEAD BOLTS(M8x1.25x12mm)(39).
B. There is an "L" decal on the LEFT PEDAL CAP(34), and an "R" decal on the RIGHT PEDAL
CAP(35). Attach the RIGHT PEDAL CAP(35) to the RIGHT PEDAL LINKAGE(5) with BUTTON HEAD
BOLTS(M8x1.25x15mm)(33).
NOTE: The LEFT and RIGHT PEDAL CAPS(34, 35) have a raised lip on three sides. Attach the LEFT
and RIGHT PEDAL CAPS(34, 35) to the LEFT and RIGHT PEDAL LINKAGES(4, 5) so that
the side without the raised lip is on the outside.
C. Position a CRANK/PEDAL ARM CONNECTOR(67, 6) as shown in the illustration, and attach it to the
RIGHT PEDAL ARM ASSEMBLY with BUTTON HEAD BOLT(M8x1.25x48mm)(31), WASHER(M8)
(72), and NYLOCK NUT(M8x1.25)(32).
Repeat the above assembly steps for left side.
L
L
LEFT PEDAL ARM ASSEMBLY
9
RIGHT PEDAL ARM ASSEMBLY
R
R