Stamina 1764 Owner's Manual page 10

ASSEMBLY INSTRUCTIONS
WARNING:
The CRANKS(67) require a special tool to remove once assembled. Read all of the
following ASSEMBLY INSTRUCTIONS before attaching the CRANKS(67).
NOTE: 1.
Align the ARROW MARK on the CRANK(67) to the WHITE MARK on the AXLE(62) when
installing the two CRANKS(67) onto the AXLE(62). Refer to inset drawing A.
2. The LEFT FLANGE NUT(M10x1.25)(69), brass color, has left hand threads and is tightened
by turning counterclockwise. The RIGHT FLANGE NUT(M10x1.25)(70), black color, has right
hand threads and is tightened by turning clockwise.
STEP 7
Place the ROLLER(43) on the back end of the LEFT PEDAL ARM ASSEMBLY(3, 4) on the REAR BASE(2).
Attach the CRANK(67) to the AXLE(62) with TOOTH LOCK WASHER(M10)(68) and LEFT FLANGE
NUT(M10x1.25)(69). SECURELY TIGHTEN the LEFT FLANGE NUT(M10x1.25)(69) with the socket
wrench. Push the CRANK CAP(97) into the CRANK(67).
CAUTION: It is possible to assemble the CRANKS(67) the wrong way as shown in inset drawings B and
C. The CRANK(67) on the RIGHT PEDAL ARM ASSEMBLY(3, 5) must be assembled in the
opposite direction from the left side. Refer to the below illustration. Use the same procedure as
above to assemble the RIGHT PEDAL ARM ASSEMBLY(3, 5).
Socket Wrench
B.
C.
L
10
A.
Arrow Mark
White Mark
R