Stamina 1764 Owner's Manual page 11

ASSEMBLY INSTRUCTIONS
STEP 8
There is an "L" decal on the LEFT PIVOTING ARM(8), and an "R" decal on the RIGHT PIVOTING ARM(9).
To assemble the LEFT PIVOTING ARM(8), place a SPACER(79) and a SPACER WASHER(ø19xø38x0.5mm
thick)(29) on the left side of the SHAFT on the UPRIGHT(17). Slide the LEFT PIVOTING ARM(8) onto
the SHAFT and secure with a LARGE WASHER(M8xø32x2.0mm thick)(23), LOCK WASHER(M8)(18),
and BUTTON HEAD BOLT(M8x1.25x20mm)(24). Attach the lower end of the LEFT PIVOTING ARM(8)
to the LEFT PEDAL LINKAGE(4) with BUTTON HEAD BOLT(M8x1.25x48mm)(31), WASHER(M8)(72),
and NYLOCK NUT(M8x1.25)(32). Repeat on the right side.
STEP 9
There is an "L" decal on the LEFT HANDLEBAR(10), and an "R" decal on the RIGHT HANDLEBAR(11).
Insert the LEFT and RIGHT HANDLEBARS(10, 11) into the LEFT and RIGHT PIVOTING ARMS(8, 9) and
secure with HEX BOLTS(M6x1x38mm)(25), ARC WASHERS(M6)(26), LOCK WASHERS(M6)(27), and
ACORN NUTS(M6x1)(28). The HEX BOLTS(M6x1x38mm)(25) must fit inside the hex-shaped holes to
properly secure the LEFT and RIGHT PIVOTING ARMS(8, 9) to the LEFT and RIGHT HANDLEBARS(10,11).
L
L
11
R
R