OfficeServ 7200 Installation guide/Ed.00
4
Installing on a Wall
This section describes how to install the OfficeServ 7200 Chassis on a wall.
4.1
Required Tools
A middle-sized cross screwdriver
An electric drill
A hammer
A wall bracket
Four plastic anchors
Four cross screws
Four mount lock screws
4.2
Wall Installation
The procedure for installing the OfficeServ 7200 Chassis on a wall by using a wall
bracket is as follows:
1) There are four screw holes on the wall bracket as shown below. Mark the four screw
holes where the wall bracket should be installed.
© SAMSUNG Electronics Co., Ltd.
Figure 2.6 Tools Required for Wall Installation
Figure 2.7 Wall Installation (1)
CHAPTER 2. Installing Chassis
Page 2-5