Table 3.4 Types Of Control Modules; Mounting Control Modules - Samsung OfficeServ 7200 Installation Manual

CHAPTER 3. Mounting and Replacing Modules
2.2

Mounting Control Modules

Mount control Modules in Slot 0 of the basic Chassis and the expansion Chassis.
The locations of Slot 0 through slot 5 are described in '1. Chassis Configuration'
section of this chapter.
Control Module
MCP
LCP
The procedure for mounting the MCP Module and the LCP Module to each slot is
as follows:
1) Check the exterior of the MCP Module and the LCP Module for any damages.
2) Align the MCP Module to the guardrails of slot 0 of the basic Chassis, and slide
the MCP Module into the slot.
Page 3-6

Table 3.4 Types of Control Modules

Slot 0 of the basic Chassis
Slot 0 of the expansion Chassis
Check the power when mounting or dismounting Modules
Check if the Chassis power is off when mounting Modules on slots. Inserting or
ejecting a Module while the power is on may damage the Module.
Figure 3.5 Mounting the Control Module to Slot 0
OfficeServ 7200 Installation guide/Ed.00
Applicable Slot
© SAMSUNG Electronics Co., Ltd.