CHAPTER 3. Mounting and Replacing Modules
5
Replacing Modules
If the OfficeServ 7200 system fails to operate normally due to an error on the power
supply Module, control Module, or interface Module, replace the Module to a new one.
The procedure for replacing a Module mounted in a slot of a Chassis is as follows:
1) Turn off the power of the Chassis.
2) When replacing a control Module, first, remove the extension cable connecting
the MCP Module to the LCP Module. Also, remove all cables connected to the
Module to be replaced.
Page 3-16
Removing Cables
Replace a Module after removing all cables connected to the Module.
Figure 3.17 Turning the Chassis Power Off
LINK1
LINK3
Figure 3.18 Removing Cable
OfficeServ 7200 Installation guide/Ed.00
© SAMSUNG Electronics Co., Ltd.