CHAPTER 3. Mounting and Replacing Modules
The Procedure for mounting the interface Module to each slot is as follows:
1) Check the exterior of the interface Module for any damages.
2) Align each Interface Module to the guardrails of the universal slot of the
OfficeServ 7200 basic Chassis or expansion Chassis, and slide the Interface
Module into the slot.
3) Push the front panel lever of the interface Module until the Module is
completely inserted into the OfficeServ 7200 main Module port.
Page 3-14
Figure 3.14 Mounting Interface Module to Slot
Figure 3.15 Inserting Control Module into the Main Module port
OfficeServ 7200 Installation guide/Ed.00
© SAMSUNG Electronics Co., Ltd.