Match Metric - Dell S6100 Configuration Manual

Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
7.6.1.0
7.5.1.0
pre-6.1.1.0
Related Commands
•
•
•
•
•
•

match metric

To match on a specified value, configure a filter.
Syntax match metric metric-value
To delete a value, use the no match metric [metric-value] command.
Parameters
metric-value
Defaults Not configured.
268 Access Control Lists (ACL)
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810
Introduced on the E-Series.
Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names were up
to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
match interface — redistribute routes that match the next-hop interface.
match ip address — redistribute routes that match an IP address.
match ip next-hop — redistribute routes that match the next-hop IP address.
match metric — redistribute routes that match a specific metric.
match route-type — redistribute routes that match a route type.
match tag — redistribute routes that match a specific tag.
Enter a value to match. The range is from zero (0) to 4294967295.