Extended Ip Acl Commands - Dell S6100 Configuration Manual

Version
9.8(0.0P2)
9.8(0.0)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.3.1.0
8.2.1.0
8.1.1.0
7.6.1.0
7.5.1.0
7.4.1.0
6.5.10
Usage Information
The order option is relevant in the context of the Policy QoS feature only. The following applies:
•
•
•
•
•
Related Commands
•
•

Extended IP ACL Commands

When an ACL is created without any rule and then applied to an interface, ACL behavior reflects an implicit permit.
The following commands configure extended IP ACLs, which in addition to the IP address, also examine the packet's protocol type.
The platform supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the
198 Access Control Lists (ACL)
Description
Introduced on the S3048-ON.
Added the no-drop parameter.
Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Add the DSCP value for ACL matching.
Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Introduced on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Added support for the non-contiguous mask and added the monitor option.
Expanded to include the optional QoS order priority for the ACL entry.
The seq sequence-number command is applicable only in an ACL group.
The order option works across ACL groups that are applied on an interface via the QoS policy framework.
The order option takes precedence over seq sequence-number.
If you do not configure sequence-number, the rules with the same order value are ordered according to
their configuration order.
If you configure sequence-number, the sequence-number is used as a tie breaker for rules with the same
order.
deny — configure a filter to drop packets.
permit — configure a filter to forward packets.
Commands Common to all ACL Types and Common IP ACL Commands sections.