Advertisement
GFI60 Wood Pellet Insert
OUTSIDE FRESH AIR CONNECTION
Outside fresh air is mandatory when installing this unit in airtight
homes and mobile homes.
A Fresh-air intake is strongly recommended for all installations.
Failure to install intake air may result in improper combustion as well
as the unit smoking during power failures.
When connecting to an outside fresh air source, do not use plastic or
combustible pipe. A 2" minimum (51 mm) ID (inside diameter) steel,
aluminum or copper pipe should be used. It is recommended, when
you are installing a fresh air system, to keep the number of bends in
the pipe to a minimum.
2" ID
(51 mm)
MASONRY FIREPLACE
INSERT INSTALLATION
Rain Cap
Clean-out tee
If holes already exist
fresh-air intake can
be taken through the
back of the fireplace
or through the ash
dump.
Outside
Wall
Optional
Elbow
Fresh-air intake
Steel Plate or Flashing
Damper Removed
or Fastened Open
Mantel (8" deep)
Min. 8" from
top of stove
Min. 6"
Floor
Protection
Masonry Fireplace
Combustible Floor
RECOMMENDED - THROUGH WALL WITH
VERTICAL RISE AND HORIZONTAL TERMINATION
INSTALLATION
NOTE - This venting configuration is only for use with the
Built-In installation.
Termination cap
90°elbow
Wall framing
Vertical section
of vent pipe
Wall strap
Horizontal
frame for
thimble
Clean
out tee
Wall thimble
Advertisement
