Deleting A Work Offset - Siemens SINUMERIK 840D Operating Manual

Setting up the machine
2.7 Work offsets
...
These value changes are available in the part program immediately or after "Reset".
2.7.6

Deleting a work offset

You have the option of deleting zero offsets. This resets the entered values.
Proceed as follows
106
Press the "WO +" or "WO -" softkey to select the next or previous
offset, respectively, within the selected area ("Active", "Base", "G54 to
G599") without first having to switch to the overview window.
If you have reached the end of the range (e.g. G599), you will switch
automatically to the beginning of the range (e.g. G54).
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Press the "Back" softkey to close the window.
1. Select the "Parameter" operating area.
2. Press the "Work offset" softkey.
3. Press the "Active", "Base" or "G54...G599" softkey.
4. Press the "Details" softkey.
5. Position the cursor on the zero offset you would like to delete.
6. Press the "Clear Offset" soft key.
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
Milling