Simultaneous Recording During Machining Of The Workpiece - Siemens SINUMERIK 840D Operating Manual

Simulating machining

5.4 Simultaneous recording during machining of the workpiece

5.4 Simultaneous recording during machining of the workpiece
If the view of the work space is blocked by coolant, for example, while the workpiece is being
machined, you can also track the program execution on the screen.
Procedure
Note
 If you switch-on simultaneous recording after the unmachined part information has
 If you switch-off simultaneous recording during machining and then switch-on the function
182
Software option
You require the option "Simultaneous recording (real-time simulation)" for
the simultaneous recording.
1. Load a program in the "AUTO" mode.
2. Press the "Sim. rec." softkey.
3. Press the <CYCLE START> key.
The machining of the workpiece is started and graphically displayed
on the screen.
4. Press the "Sim. rec." softkey again to stop the recording.
already been processed in the program, only traversing paths and tool are displayed.
again at a later time, then the traversing paths generated in the intermediate time will not
be displayed.
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
Milling