Siemens SINUMERIK 840D Operating Manual page 489

Hide thumbs Also See for SINUMERIK 840D:
Table of Contents

Advertisement

Procedure
Several magazines
If you have set up several magazines, then the "...relocate from magazine... location... to..."
window appears after pressing the "Relocate" softkey.
Select the desired magazine and location, and confirm your selection with "OK" to load the
tool.
Milling
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
1.
The magazine list is opened.
2.
Position the cursor on the tool that you wish to relocate to a different
magazine location.
3.
Press the "Relocate" softkey.
The "... relocate from location ... to location ..." window is displayed.
The "Location" field is pre-assigned with the number of the first empty
magazine location.
4.
Press the "OK" softkey to relocate the tool to the recommended
magazine location.
- OR -
Enter the required magazine, enter the location number and press the
"OK" softkey.
- OR -
Enter the number "9998" or the number "9999" into the "... magazine"
field in order to select the buffer as well as the required buffer location
in the "Location" field.
- OR -
Press the "Spindle" softkey to load a tool into the spindle and press
the "OK" softkey.
The tool is relocated to the specified magazine location, in the spindle
or in the buffer.
Tool management
12.8 Magazine
489

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik828d

Table of Contents