Table of Contents
Advertisement
5
SCAN OPERATION
I Scan start/stop
D Preparation
Scan resume condition (p. ??); program the scan edges
(p. ??); program 2 or more memory channels (p. ??); set skip
settings (p. ??), if desired.
D Operation
q Push [V/MHz•SCAN] to select VFO mode for full/pro-
grammed scan; or push [MR•SKIP] to select memory
mode for memory/bank scan.
• Select the desired bank with [TS•MODE] for bank scan.
w Set the squelch level to the point where noise is just
muted.
e Push [V/MHz•SCAN] for 1 sec. to start the scan.
• To change the scanning direction, rotate [DIAL].
• The memory channel readout blinks the scan type as follows:
r Push [TS•MODE] to switch full and programmed scan
(P00 to P24), if VFO is selected in step q.
t To stop the scan, push [V/MHz•SCAN].
21
About the scanning steps: The selected tuning step in
each frequency band (in VFO mode) is used during scan
IMPORTANT!: To perform memory or bank scan, 2 or
more memory/bank channels MUST be programmed, oth-
erwise the scan will not start.
The bank-link setting can be changed in expanded set
mode. See page ?? for details.
Advertisement
Table of Contents
