Avaya H.323 9608 Installation And Management Manual page 31

4. The phone activates the Ethernet line interface , the PC Ethernet jack, and dial pad
5. The IP phone sends a request to the DHCP server and invokes the DHCP
6. The system determines the DHCP protocol , IPv4 or IPv6 protocol, and the
Installing and maintaining Avaya IP Deskphone H.323 9608, 9608G, 9611G, 9621G, and 9641GJanuary 2014
input to allow the start of procedures. The activation occurs soon after power-up or
a reset.
The phone displays the speed of the Ethernet interface in Mbps, that is, 10, 100, or
1000. The phone then displays the message
the software determines whether the interface is 10 Mbps, 100 Mbps, or 1000
Mbps.
Note:
The Ethernet speed is the LAN interface speed for both the phone and any
attached computer, if the administrator has not disabled the latter interface by a
PHY2STAT setting.
Important:
When you press the star (*) after the system displays a
The initialization process can support an interrupt that invokes the Craft Access
entry procedure to allow manual settings, only if the local dialpad procedure
status (PROCSTAT) system value is 0. The zero PROCSTAT value provides full
access to local procedures. If PROCSTAT is 1 the Craft Access entry procedure
can be invoked only when a
procedure is available. For information, see
Administrative (Craft) Options.
process.
The phone displays one of the following messages:
• DHCP: s secs * to program
•
DHCP: s secs VLAN ID = n
where s is the number of seconds that have elapsed after the DHCP process was
started. The phone displays the first message if 802.1Q tagging is off and access
to local programming procedures is not disabled or restricted. For more information,
see Chapter 3: Using Local Administrative (Craft) Options .
displays the second message if 802.1Q tagging is on and access to local
programming procedures is disabled or restricted. If the first and second message
alternate every 2 seconds, 802.1Q tagging is on. When the phone displays both
messages alternately, access to local programming procedures is not disabled or
restricted. Finally, the phone displays the third message if 802.1Q tagging is off and
access to local programming procedures is disabled or restricted.
applicable parameters that are enabled.
Understanding the plug in and reset process
No Ethernet * to program
message displays, but only the VIEW
* to program
Chapter 5: Using Local
on page 37
until
message.
* to program
on page 37 The phone
31