D-Link DVG-N5402G/ACF User Manual page 124

DVG-N5402G/ACF Wireless AC1200 Dual Band Gigabit Router
with Fiber WAN Port, 3G/LTE Support, 2 FXS Ports, 1 PSTN
(lifeline) Port, and USB Port
User Manual
Parameter
Encryption
Authentication
algorithm
MTU
Keep Alive
Extra options
Dial on demand
Static IP Address
PPP debug
IP received
Isolate connection
Enable RIP
Select a method of MPPE encryption.
No encrypt: MPPE encryption is not applied.
•
MPPE 40/128 bit: MPPE encryption with a 40-bit or 128-bit
•
key is applied.
MPPE 40 bit: MPPE encryption with a 40-bit key is applied.
•
MPPE 128 bit: MPPE encryption with a 128-bit key is
•
applied.
MPPE encryption can be applied only if the MS-CHAP, MS-
CHAP-V2, or AUTO value is selected from the Authentication
algorithm drop-down list.
Select a required authentication method from the drop-down list or
leave the AUTO value.
The maximum size of units transmitted by the interface.
Select the checkbox if you want the router to
your ISP even when the connection has been inactive for a specified
period of time. When the checkbox is selected, the LCP interval
and LCP fails fields are available. Specify the required values.
Advanced options of the pppd daemon which need to be specified
for this connection. Optional.
Select the checkbox if you want the router to establish connection to
the Internet on demand. In the Maximum idle time field, specify a
period of inactivity (in seconds) after which the connection should
be terminated.
Fill in the field if you want to use a static IP address to access the
Internet.
Select the checkbox if you want to log
debugging.
The IP address assigned by the ISP.
When the checkbox is selected, the router uses an alternate routing
table for this connection. Select the checkbox only when your ISP
requires this.
Select the checkbox to allow using RIP for this connection.
Page 124 of 259
Configuring via Web-based Interface
Description
keep you connected to
all data on PPP connection