Jumpers Setting - HP ProLiant SL165s G7 Maintenance And Service Manual

Item Designator
17 J65
18 J49
19 J8
20 J81
21 J100
22 J66, J69
23 J55
24 J13
25 J98
26 J56
27 J78
28 J23
29 J20
30 BH1
31 J6
CAUTION: The TPM is not a customer-removable part.
Any attempt to remove an installed TPM from the system board breaks or disfigures the TPM security
rivet. Upon locating a broken or disfigured rivet on an installed TPM, administrators should consider
the system compromised and take appropriate measures to ensure the integrity of the system data.
If you suspect a TPM board failure, leave the TPM installed and remove the system board. Contact
an HP authorized service provider for a replacement system board and TPM board.

Jumpers Setting

Table 4 describes the jumper settings.
Table 4 System configuration switch settings
Jumper
J1
J1
J1
J1
Description
Fan connector 5
Internal USB 2.0 port
Front panel USB 2.0 port
SD card USB 2.0 port
SAS LED connector
Fan connectors 6/7
Power backplane control connector
Mini-SAS connector for SATA
Front panel header
TPM connector
PCIe x4 slot
ODD 1 SATA connector
ODD 2 SATA connector
3V CMOS battery (CR2032)
NMI jumper
Status
1-2, Open = normal
Short = clear BMC password
3-4, Open = normal
Short = clear BMC recovery
5-6, Open = normal
Short = BIOS recovery
7-8, Open = normal
Short = clear CMOS
Connectors, Switches, and LEDs 59