HP ProLiant SL165s G7 Maintenance And Service Manual page 31

Hide thumbs Also See for ProLiant SL165s G7:
Table of Contents

Advertisement

When folding a flat ribbon cable, never fold to a sharp crease. Sharp creases may damage the
wires.
Some flat ribbon cables come pre-folded. Never change the folds on these cables.
Do not sharply bend any cable. A sharp bend can break the internal wires.
Never bend a SATA data cable tighter than a 30 mm (1.18 in) radius.
Never crease a SATA data cable.
Do not rely on components like the drive cage, power supply, or system cover to push cables
down into the chassis.
To remove power supply cables from the system board connectors (J36):
Squeeze on the top of the retaining latch attached to the cable end of the connector.
1.
Grasp the cable end of the connector and pull it straight up.
2.
CAUTION: Always pull the connector - NEVER pull on the cable. Pulling on the cable could damage
the cable and result in a failed power supply.
Figure 3 Unplugging power cables
Removal and Replacement Procedures 31

Advertisement

Table of Contents
loading

Table of Contents