Sheets Cannot Be Stapled Properly (Finisher Sr5070 / Booklet Finisher Sr5080) - Ricoh PRO C5200S Operating Instructions Troubleshooting: Tcru/Oru

5. Post-Processing Option Troubleshooting
• There is a tight curl on a delivered set of stapled sheets.
• Limp paper such as thin or recycled paper is used.
Output tray
Paper feed direction
Solution:
1. Load the sheets the other way up.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Contact your service representative.
Sheets Cannot Be Stapled Properly (Finisher SR5070 / Booklet Finisher
SR5080)
Cause:
When the sheets are fed to the staple unit inside the finisher, they may be overlaid, resulting in a
misalignment of 5 mm (0.2 inches) relative to each other after stapling.
When coated or other paper producing higher paper-to-paper friction is used, the paper edges are not
aligned properly, resulting in misaligned stapling.
This may occur if:
• Coated or other paper producing higher paper-to-paper friction is used.
• Thin or other limp paper is used.
Solution:
Reduce the number of sheets to be stapled.
92
Trailing edge
too near exit
Paper exit
CEZ593