Electrical Safety - DeWalt DCN692 Original Instructions Manual

ENGLISH
INTENDED USE
The DCN692 and DCN695 cordless framing nailers
have been designed for driving nails into wooden
workpieces.
The DCN692 cordless framing nailer is designed
for sequential/bump modes. This nailer is designed
for sequential/bump modes MUST NOT be
used on scaffoldings, stairs, ladders or ladder-like
constructions, e.g., roof laths. For exemptions check
your local national workplace regulations.
The DCN695 cordless framing nailer is designed for
sequential use only, whether in standard sequential
TM
mode, or RapidCycle sequential mode for faster
nailing. Nailers designed for sequential only mode
MAY BE used on scaffoldings, stairs, ladders or
ladder-like constructions, e.g., roof laths.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
These cordless nailers are professional power tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• Young children and the infirm. This appliance
is not intended for use by young children or
infirm persons without supervision.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your D WALT charger is double insulated
E
in accordance with EN 60335; therefore
no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
56
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see Technical Data). The minimum conductor size
is 1 mm 2 ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: Prior to assembly and
adjustment, always remove the
battery pack. Always lock off the
tool before inserting or removing
the battery pack.
WARNING: Use only D
packs and chargers.
Inserting and Removing the
Battery Pack from the Tool (fi g. 2)
WARNING: To reduce the risk of
serious personal injury, lock tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
NOTE: Make sure your battery pack (l) is fully
charged. The battery packs supplied will not
necessarily be fully charged.
TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE
1. Align the notch inside the tool's handle with the
battery pack (l).
2. Slide the battery pack firmly into the handle until
you hear the lock snap into place.
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the release button (o) and slide the
battery pack out of the tool handle.
2. Insert battery pack into the charger as
described in the charger section of this manual.
WALT battery
E