Installing The Indoor Unit - Daikin EKHVWQ002AAV3 Installation Manual

6.4. Installing the indoor unit

■
Unpack the EKHVWQ according to unpacking instruction sheet.
■
Place the heat pump module in the appropriate installation
location as close as possible to the installation location.
■
Level the heat pump module to a stable position using the
levelling feet. The maximum allowed deviation from a horizontal
position is 1°.
■
Unpack the EKHHS according to the unpacking instructions
delivered with the unit.
■
Perform the electrical wiring work as described in the chapter
"Electrical wiring work" on page
■
Connect the system to the water circuit as described in the
chapter "Piping connection work" on page
■
Fill the system with water as described in the chapter
water" on page 11.
■
To make the casing completely sealed, plug the knockout holes
with putty or insulation materials (to be prepared on-site).
■
Perform the pre-operation checks as described in the chapter
"Start-up and configuration" on page
■
Close the unit
1 Put the sound bottom plates at the bottom of the unit.
2 Close the decoration panels.
1 1
2x
EKHVWQ002AAV3 + EKHHS200+260AA1V3
Domestic hot water heat pump
4PW65342-1A – 10.2010
12.
10.
"Charging
16.
2x
3 Align the side panels of the heat pump module with the
domestic hot water tank module side panels.
4 Fix the front panel to the domestic hot water tank module.
1 1
2x
Installation manual
9