Table of Contents
Advertisement
Chapter 2
Board Installation
Quick References for Jumpers
In this manual, the terms "closed" and "on" are used when referring to jumpers
(or jumper pins) that are active; "open" and "off" are used when referring to
jumpers (or jumper pins) that are inactive. See the Figure 2-1 for examples of
"on" and "off" pins and jumpers. The square pin in the diagram is Pin 1.
Jumpers and pins are connected by slipping the blue plastic jumper connector
overtop of two adjacent jumper pins (indicated by 1-2 or 2-3). The metal rod
inside the plastic shell bridges the gap between the two pins, completing the
circuit. See Figure 2-2 for more example of pin connections.
2 pin jumpers
off
Figure 2-1
The tables and maps on the following pages will help you set the jumpers for
CPU speed, Infrared, and external connector pin assignments, among others.
The miniature motherboard maps will help you locate the jumpers on your board.
A full-page map of the motherboard can be found on the next two pages.
on
12
3 (or more) pin jumpers
1-2
2-3
1
1
2
2
3
3
Figure 2-2
open
1
2
3
http://www.tyan.com
Advertisement
Table of Contents
