Troubleshooting; Regulatory - Cisco Meraki MR72 Hardware Installation Manual

4.4 Verify Device Functionality and Test Network
Coverage
1. Check LEDs The Radio Power LED should be solid white. If it is
cycling rainbow, the firmware is automatically upgrading and the
LED should turn white when the upgrade is completed (normally
in under thirty minutes).
2. Note: Your MR72 must have an active route to the Internet to
check and upgrade its firmware.
3. Verify access point connectivity Use any 802.11 client device to
connect to the MR72 and verify proper connectivity using the
client's web browser.
4. Check network coverage Confirm that you have good signal
strength throughout your coverage area. You can use the signal
strength meter on a laptop, smart phone, or other wireless
device.

5 Troubleshooting

Reference the Meraki knowledge base at
http://meraki.com/support/#kb for additional information and
troubleshooting tips.

6 Regulatory

FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference