Mount The Mr - Cisco Meraki MR72 Hardware Installation Manual

orientation.

4.2.3 Mount the MR72

Insert the posts on the mount plate into the attachment slots on the
access point.
4.2.3.1 Attach Antennas
Remove protective plastic covers from all four N-type RF connectors.
Attach appropriate antennas (and protective boots if included).
4.2.3.2 Aim Antennas
If you are using directional antennas, aim them appropriately to ensure
optimal performance for your specific network topography.
Omnidirectional antennas perform best in a mesh network when
oriented vertically.
4.2.3.3 Powering the MR72 with the Meraki 802.3at Power over
Ethernet Injector (sold separately)
1. Plug the power cord into the PoE Injector and the other end
into wall power.
2. Plug an Ethernet cable that is connected to an active Ethernet
connection into the "IN" port on the injector.
3. Route Ethernet cable from the "OUT" port on the injector to
the Ethernet port in the bay of the MR72.
For more details, see Meraki 802.3at Power Over Ethernet Injector
datasheet.
4.2.3.4 Powering the MR72 with an 802.3at Power over Ethernet
Switch
Route Ethernet cable from a port on an active 802.3at PoE switch to
the Ethernet port in the bay of the MR72.