Daikin E-Series Service Manual page 208

SiENBE12-620
6. Maintenance (for service personnel)
Only a qualified service person is allowed to perform
maintenance
IMPORTANT!
• Before obtaining access to terminal devices, all power
supply circuits must me interrupted
• To clean the air conditioner, be sure to stop operation, and
turn the power switch off. Otherwise, an electric shock and
injury may result.
• Do not wash the air conditioner with water
Doing so may result in an electric shock.
• Be careful with a scaffold or staging. Caution must be
exercised because of work at a high place.
Fig. 2
Fig. 3
Fig. 4
Fig. 5
System Configuration
How to clean the air filter
Clean the air filter when the display shows "
(TIME TO CLEAN AIR FILTER).
It will display that it will operate for a set amount of time.
Increase the frequency of cleaning if the unit is installed in a
room where the air is extremely contaminated.
If the dirt becomes impossible to clean, change the air filter
(Air filter for exchange is optional).
1. Open the suction grille.
2. Remove the air filters.
knob
3. Clean the air filter.
tab
NOTE
•
clip
•
4. Fix the air filter.
5. Close the suction grille.
6. After turning on the power, press FILTER SIGN RESET
Slide both knobs simultaneously as shown and then pull
them downward.
(Do the same procedure for closing.)
(Refer Fig. 2)
Push the 2 tabs up, and slowly lower the grille.
(Refer to Fig. 3)
Use a vacuum cleaner A) or wash the air filter with water B).
A) Using a vacuum cleaner
B) Washing with water
When tha air filter is very
dirty, use soft brush and
neutral detergent.
Remove water and dry in the shade.
Do not wash the air conditioner with hot water of more than
50°C, as doing so may result in discoloration and/or
deformation.
Do not expose it to fire, as doing so may result in burning.
Set the hatch of the air filter to the fook of the suction grille,
and fix the air filter
(Refer to Fig. 5)
Refer to item No. 1.
button.
The "TIME TO CLEAN AIR FILTER" display vanishes.
Instruction
"
199