SiENBE12-620
Adjustment
For programming TEMPERATURE, FAN SPEED and AIR
FLOW DIRECTION, follow the procedure shown below.
Temperature setting
Press TEMPERATURE SETTING button and program the
setting temperature.
Each time this button is pressed, setting
temperature rises 1°C
Each time this button is pressed, setting
temperature lowers 1°C
•
The setting is impossible for fan operation
NOTE
•
The setting temperature range of the remote control is
16°C to 32°C.
Fan speed control
Press FAN SPEED CONTROL button.
High or Low fan speed can be selected.
The microchip may sometimes control the fan speed in order
to protect the unit.
Air flow direction adjust
•
There are 2 ways of adjusting the air discharge angle.
1
. A. Up and down adjustment
2
. B. Left and right direction
Fig. 1
A. Up and down
direction
B. Left and right direction
A. Up and down direction
•
The movable limit of the flap is changeable.
Contact your Daikin dealer for details.
System Configuration
Press the AIR FLOW DIRECTION ADJUST button
to select the air direction as following.
The AIR FLOW FLAP display swings as
shown left and the air flow direction
continuously varies. (Automatic swing
setting)
Press AIR FLOW DIRECTION ADJUST
button to select the air direction of your
choice.
The AIR FLOW FLAP display stops
swinging and the air flow direction is fixed
(Fixed air flow direction setting).
Movement of the air flow flap
For the following conditions, micro computer controls the air
flow direction so it may be different from the display.
Operation
Cooling
mode
•
When room
temperature is
lower than the set
temperature
Operation
condition
•
When operating continuously at
horizontal air flow direction
Operation mode includes automatic operation.
B. Left and right direction
•
Adjusting air flow direction in the left and right direction.
(Refer to Fig.1)
NOTE
•
Only make adjustments after you have stopped the air flow
direction swing in a position where adjustments are
possible. Your hand may get caught if you attempt to make
adjustments while the unit is swinging.
Instruction
Heating
•
When room
temperature is
higher than the
set temperature
•
At defrost
operation
197