Daikin E-Series Service Manual page 175

Instruction
FILTERS
1. Open the front panel.
2. Pull out the air filters.
3. Take off the Titanium Apatite Photocatalytic
4. Clean or replace each filter.
5. Set the air filter and the Titanium Apatite
Air Filter
1. Wash the air filters with water or clean them
Titanium Apatite Photocatalytic Air-Purifying Filter (gray)
The Titanium Apatite Photocatalytic Air-Purifying
Filter can be renewed by washing it with water once
every 6 months. We recommend replacing it once
every 3 years.
[Maintenance]
1. Remove dust with a vacuum cleaner and wash lightly with water.
2. If it is very dirty, soak it for 10 to 15 minutes in water mixed with a neutral cleaning
3. Do not remove filter from frame when washing with water.
4. After washing, shake off remaining water and dry in the shade.
5. Since the material is made out of paper, do not wring out the filter when removing
[Replacement]
1. Remove the tabs on the filter frame and replace with a new filter.
166
• Open the front panel by placing a finger on
the panel tab on either side of the front panel
and then secure it using the supporting plate
on the right.
• Push a little upwards the tab at the center of
each air filter, then pull it down.
Air-Purifying Filter.
• Hold the recessed parts of the frame and
unhook the four claws.
• See figure.
Photocatalytic Air-Purifying Filter as they
were and close the front panel.
• Be sure to insert the two tabs below.
• Return the supporting plate to its previous
position.
• Press either side of the front panel.
with vacuum cleaner.
• If the dust does not come off easily, wash
them with neutral detergent thinned with
lukewarm water, then dry them up in the
shade.
• It is recommended to clean the air filters
every two weeks.
agent.
water from it.
• Dispose of the old filter as flammable waste.
SiENBE12-620
Supporting plate
Titanium Apatite
Photocatalytic
Air-Purifying Filter
Filter Frame
Tab
Push
T a b
System Configuration
Air filter