SiBE12-713
FTK(X)S 20/25/35 C
Care and Cleaning
CAUTION
Units
Indoor unit, Outdoor unit and Remote controller
1. Wipe them with dry soft cloth.
Front panel
1. Open the front panel.
• Hold the panel by the tabs on the two sides and lift
it until it stops with a click.
2. Remove the front panel.
• Supporting the front panel with one hand, release
the lock by sliding down the knob with the other
hand.
• To remove the front panel, pull it toward yourself
with both hands.
3. Clean the front panel.
• Wipe it with a soft cloth soaked in water.
• Only neutral detergent may be used.
• In case of washing the panel with water, dry it with
cloth, dry it up in the shade after washing.
4. Attach the front panel.
• Set the 3 keys of the front panel into the slots
and push them in all the way.
• Close the front panel slowly and push the
panel at the 3 points.
( 1 on each side and 1 in the middle.)
• Check to see if the rotating axis in the upper
center section is moving.
CAUTION
• Don't touch the metal parts of the indoor unit. If you touch those parts, this may cause an injury .
• When removing or attaching the front panel, use a robust and stable stool and watch your steps carefully.
• When removing or attaching the front panel, support the panel securely with hand to prevent it from falling.
• For cleaning, do not use hot water above 40˚C, benzine, gasoline, thinner, nor other volatile oils, pol-
ishing compound, scrubbing brushes, nor other hand stuff.
• After cleaning, make sure that the front panel is securely fixed.
Operation Manual
Before cleaning, be sure to stop the operation and
turn the breaker OFF.
Instruction
161