Rear Seat - Volvo P 120 Service Manual

l uggage compartment lid is counter-balanced with
torsion rods and can be set in any position when
opening. On chassis up to number 20999, the lock-
i ng device is placed on the body below the lid,
and on vehicles with effect from chassis number
21000, the locking device is fitted on the lid.
Interior fittings and upholstery
FRONT SEATS, LATE PRODUCTION
The front seats are built up on a tubular frame. The
padding consists of foam plastic which is covered
by fabric-backed vinyl. The seat can be adjusted
l ongitudinally by releasing the catch (3, Fig. 5), and
sliding the seat. The seat can be adjusted vertically
at the attachment (4) which is provided with holes
at different heights. The seat can be tilted to the
desired position by means of the adjusting device
(5). The backrest inclination is variably adjustable
by means of the handwheel (2) which operates an
eccentric. The seat is provided with an adjustable
l umbar support (see Fig. 7), the tension of which
Bild 5. Front seat (4-door)
1. Adjustment of lumbar support
2. Adjustment of backrest inclination
3. Longitudinal adjustment
4. Adjustment of seat height
5. Adjustment of seat inclination
i s adjusted with a screw (1, Fig. 5 and 3, Fig. 7)
on each side of the backrest. The seat cushions are
attached to the seat frame by means of press-
fasteners.

REAR SEAT

The rear seat and backrest are built up in principle
i n the same way as the front seats, although in this
case the seat frame consists of a wooden frame.
DOOR UPHOLSTERY
The door upholstery consists of wood-fibre sheeting
lined with non-woven padding and covered with
upholstery material. It is secured to the door by
means of clips. The front armrest is made of moul-
ded plastic and is screwed to the inner plate of the
door.
HEADLINING
The headlining consists of plastic material stretched
on roof ribs and secured in retainers fitted on the
upper limit of the body sides.
COVERING FOR BULKHEAD AND FLOOR
The sides of the bulkhead are lined with millboard
which is attached with clips. The bulkhead is
covered with plastic-lined felt matting. The floor is
covered with rubber mats.
Bumpers
The bumpers are composed of three parts and the
upper joints are provided with overriders. The bum-
pers are fitted on four support bars, of which the
front ones are attached to the front side members
and the rear ones to the rear side members.
P 120
8-3