Table of Contents
Advertisement
P 120
Rear door
1.
Fit the lock (11, Fig. 27) with remote control
(13) in the door without tightening the screws.
2.
Adjust measurement A, Fig. 28 to 17±0.5 mm
(0.67 ± 0.02") by turning the lock. Tighten the
l ock hard. If it is not possible to obtain the
correct measurement for A by turning the lock
after it has been tightened up as near to A as
possible, the remaining adjustment is done by
bending the lever (5). Measurement A must be
checked within the specified tolerances.
The remote control (13) with split pin (12)
3.
fitted is pushed backwards so that the lever
(10) stops against the lock (11). The remote
control is screwed on in this position. Remove
the split pin (12).
4.
Fit the lever (17) and connect the link (16)
to the lever (1).
5.
Set the lever (7) in the locked position, i.e.
backwards against the lock and lever (14) in
the rear catch position. Check through the
control hole (12) that the lever moves fully
to the catch position. In this position the lever
(14) is locked to the link (16) with screws at
the clips (15). Check that the link (16) does
not rub against the inner plate of the door.
On the other hand it must not be bent out so
much that it rubs against the screws of the
i nner trim moulding.
Fig. 27.
Adjusting the rear door lock
1.
Outer handle
2.
Locknut
3.
Adjusting screw
4.
Pin (for checking)
5.
Lever
Link
6.
7.
Lever
8.
Lever
9.
Locking spring
10.
Lever
11.
Lock
12.
Split pin
13.
Remote control
14.
Lever
Clip
15.
16.
Link
17.
Lever
18.
Locking knob
8-1 2
' F ig. 28.
Adjusting measurements for lock
Fig. 29.
Striker block
Advertisement
Table of Contents
