Table of Contents
Advertisement
DISMANTLING THE DOOR HANDLES
1.
Unscrew the two screws which hold the press-
button and lock plunger to the door handle,
see Fig. 23.
2.
Press out the locking pins as shown in Fig. 24.
3.
Turn the key backwards and forwards a few
ti mes in the press-button at the same time as
pulling outwards, when the lock plunger will
release and can be pulled out as shown in
Fig. 25.
FITTING AND ADJUSTING THE LOCKS
Front door
1.
Fit the lock (10, Fig. 26) with remote control
(12) in the door without tightening the screws.
2.
Adjust measurement A, Fig. 28 to 15±0.5 mm
(0.59 ± 0.02") by turning the lock. Tighten the
l ock hard. If it is not possible to obtain the
correct measurement for A by turning the lock
after it has been tightened up as near to A as
possible, the remaining adjustment is done
by bending the lever (5). Measurement A must
be checked within the specified tolerances.
3.
The remote control (12) with split pin (11)
fitted is pushed backwards so that the lever
(9) stops against the lock (10). The remote
control is screwed on in this position. Remove
the split pin (11).
4.
Fit the lever (7) for the inner locking knob (15).
Fig. 26.
Adjusting the front door lock
1.
Outer handle
2.
Lock nut
3.
Adjusting screw
4.
Pin (for checking)
5.
Lever
6.
Link
7.
Lever.
8.
Lever
9.
Lever
1 0.
Lock
11.
Split pin
12.
Remote control
13.
Locking spring
14.
Lever
15.
Locking knob
Fig. 24.
Pressing out the locking pin
Fig. 25.
Press-button dismantled
P 120
VOLVO
23243
VOLVO
23244
VOLVO
1 01
44
8-11
Advertisement
Table of Contents
