Front Seats - Volvo P 120 Service Manual

P 120
Fig. 10. Roof section, Station Wagon
The roof section (Fig. 10) consists of the roof
plate, windscreen member, two roof arches and
rear member.
Doors and openings
The doors on the Station Wagon are similar to those
on the 4-door model. The tailgate consists of an
upper and lower part. The hinges of the upper
tailgate are attached to the rear edge of the roof
section and those of the lower tailgate are bolted
i n the rear cross-member. The inside of the lower
tailgate is provided with a cover plate and mat
which are attached by means of screws. Both tail-
gate sections are locked by means of a common
l ock which is bolted on to the lower tailgate. Each
of the tailgate sections is provided with a support
for holding it in the open position. Opening of the
upper tailgate is facilitated by means of a gas
spring, i.e. a piston which runs in an enclosed gas-
filled cylinder. There are four different opening
positions.
Interior fittings and upholstery

FRONT SEATS

See the corresponding section for the 4-door
model.
Fig. 11. Catch device for rear seat, Station Wagon
1. Eccentric
2. Pull rods
REAR SEAT
The rear seat is built up of springs on a frame and
has foam plastic padding which is covered with
vinyl. The seat cushion is provided with two hinges
at the lower front edge and can if necessary be
tipped up against the front seats. It is covered with
a mat underneath and forms the front limit of the
l oading space when in the tipped-up position.
The backrest consists of a back plate fitted with
rubber bands. The padding consists of foam plastic
and the upholstery of fabric-backed vinyl. The rear
side of the back plate is provided with a mat and
when folded down forms an extension of the floor
i n the loading space. The backrest is locked in the
normal position by a spring-loaded catch device,
see Fig. 11, the handle (4) of which operates the
l atches through an eccentric (1) and pull rods (2).
The lower corners of the backrest rest partly on a
fixed catch and partly (on the left-hand side) on a
sprung catch.
Bumpers
The bumpers are the same as on the 4-door model
except that the rear overriders serve as footsteps,
the upper sides of which are rubber-covered.
3. Catch sleeve
4. Handle