Removing The Backrest; Front Seats - Volvo P 120 Service Manual

SEATS

Front seats

REMOVING, EARLY PRODUCTION
Lift out the seat cushion. Press down the catch for
adjusting the longitudinal position of the seat and
push the seat forwards until the slide rails release
from the frame. It may be necessary to lift the pull
wire for the catch halfway between the slide rails.
An intermediate production type has a plastic wed-
ge which limits the movement of the catch. This
wedge must be taken out before the seat can be
removed.
REMOVING, LATE PRODUCTION
Unfasten the press-button which holds the seat
cushion to the frame and remove the seat cushion.
Unscrew the four attaching screws for the slide rails.
Lift off the seat.
ADJUSTING THE FRONT SEAT, LATE PRODUCTION
1.
The inclination of the seat is adjusted with the
eyebolt (1, Fig. 64) at the front edge of the
seat. Slacken the adjusting screw and adjust
the eyebolt to the desired position.
2. The height of the seat is adjusted by attaching
the rail in a suitable hole in the bracket (2).
3.
The lumbar support is adjusted with the screw
(3). On a number of earlier vehicles with lum-
bar support where the adjusting device does
not have a countersink, the adjusting screw
can most easily be found by pressing the up-
holstery at the adjusting screw hole slightly
downwards and backwards.
Rear seat, Station Wagon

REMOVING THE BACKREST

Release the catch and tip the backrest slightly for-
wards. Move aside the nylon washer at the lower
l eft-hand corner of the backrest and insert a narrow
screwdriver as shown in Fig. 65. Press in the conical
catch pin and lift out the backrest.
Fig, 63.
Attachment of rear ventilation window
Fig. 64.
1. Adjustment
2. Adjustment
3. Adjustment of lumbar support
4.
Longitudinal adjustment
5. Adjustment of backrest inclination
P 120
Front seat
seat inclination
of
seat height
of
seat
of
8-23