Lcd Display - YASKAWA Z1000 User Manual

4.2 Using the HOA Keypad
u

LCD Display

No. Name
1 Operation Mode Menus
2 Mode Display Area
3 Ready
4 Data Display
Frequency
Reference
5
<1>
Assignment
LOCAL/REMOTE
6
<2>
Display
Function Key 2
7
(F2)
108
1
9 8
Figure 4.2 LCD Display
Table 4.1 Display and Contents
Display
MODE Displayed when in Mode Selection.
MONITR Displayed when in Monitor Mode.
VERIFY Indicates the Verify Menu.
PRMSET Displayed when in Parameter Setting Mode.
A.TUNE Displayed during Auto-Tuning.
SETUP Displayed when in Setup Mode.
DRV Displayed when in Drive Mode.
PRG Displayed when in Programming Mode.
Rdy Indicates the drive is ready to run.
— Displays specific data and operation data.
OPR Displayed when the frequency reference is assigned to the HOA keypad.
Displayed when the frequency reference is assigned to the MEMOBUS/Modbus Communication
COM
Inputs of the drive.
OP Displayed when the frequency reference is assigned to option card connected to the drive.
AI Displayed when the function reference is assigned to an analog input.
OFF Displayed when HAND mode is OFF.
RSEQ Displayed when the run command is supplied from a remote source.
LSEQ Displayed when the run command is supplied from the operator keypad.
RREF Displayed when the run command is supplied from a remote source.
LREF Displayed when the run command is supplied from the operator keypad.
FWD/REV Pressing
F2
DATA
F2
Pressing
→
F2
Pressing
RESET
F2
Pressing
Monitor
F2
Pressing
DRV/BYP The multi-function relay selected Drive/Bypass contact will be toggled.
RUNBYP The multi-function relay selected to RUN Bypass will be toggled.
RLY The multi-function relay selected to Relay operator control will be toggled.
2 3
]
7
Content
switches between forward and reverse.
scrolls to the next display.
scrolls the cursor to the right.
resets the existing drive fault error.
switches Monitor mode.
YASKAWA ELECTRIC TOEP C710616 45F YASKAWA AC Drive – Z1000 User Manual
4
5
6