Removing The Video Board Assembly; Removing The Mecha Chassis - JVC DX-U10A Service Manual

3.1.3 Removing the VIDEO BOARD assembly

(See Fig.7, 8)
(1) Disconnect the card wire from MAIN BOARD assembly
connected to connector
sembly. (See Fig.7)
(2) Disconnect the card wire from SURROUND AMP BOARD
assembly connected to connector
BOARD assembly. (See Fig.7)
(3) Remove the three screws D attaching the VIDEO BOARD
assembly. (See Fig.8)

3.1.4 Removing the MECHA CHASSIS

(See Fig.9, 10)
(1) Remove the two screws E attaching the MECHA CHAS-
SIS. (See Fig.9)
(2) Remove the two screws F attaching the both side of
MECHA CHASSIS (See Fig.10)
1-10 (No.MB616<Rev.002>)
CN920 of the VIDEO BOARD as-
CN931 of the VIDEO
CN920 CN931
Fig.7
D
Fig.8
E
Fig.9
F
Fig.10