0H50-010
Confirming IP Address Settings
NOTE
If the machine is not connected to the network properly:
The IP address is displayed as "0.0.0.0".
When the startup time setting is specified:
The IP address, subnet mask, and gateway address will be displayed when the specified time has elapsed.
e-Manual -> "Specifying a Delay Before Establishing the Network Connection"
When the machine is connected to a switching hub:
The machine may not be able to connect to a network even if your network settings are appropriate. In this case, the
startup time of the machine needs to be set to a waiting state.
e-Manual -> "Specifying a Delay Before Establishing the Network Connection"
Confirming IPv4 address settings
1
Press
(Status Monitor/Cancel).
2
Press [
] or [
] to highlight <Network Information>, and then press [OK].
3
Press [
] or [
] to highlight <IPv4>, and then press [OK].
4
Press [
] or [
] to highlight the option you want to confirm, and then press [OK].
Downloaded from ManualsPrinter.com Manuals