Specify The Ip Address Settings - Canon IMAGECLASS MF7400 SERIES Starter Manual

Specify the IP Address Settings

An IP address must be specified in order to enable communication between the machine and computer.
–
It is recommended that the network administrator perform the following procedures.
–
Before performing the following procedure, make sure that the machine is turned on and connected to a network.
–
This machine is set by default to automatically draw an IP address using DHCP. If your network server or router is configured to provide a
DHCP address, all you need to do is connect a network cable and turn on the machine. The machine will draw an IP address automatically.
–
This machine also supports automatic IP addresses using BOOTP and RARP protocols. If you use these protocols, select [DHCP] at step 7 of
the following procedures.
–
This machine supports IPv. (See Chapter , "Network, " in the Reference Guide )
1
Press (Additional Functions).
2
Press [System Settings].
3
Press [Network Settings].
4
Press [TCP/IP Settings].
5
Press [IPv4 Settings].
To set up an IPv address, see Chapter , "Network, " in the
Reference Guide.