Sony SLV-D100 Operating Instructions Manual page 14

There are many ways in which your DVD-VCR can be hooked up. To hook up your
DVD-VCR so that it works best for you, first scan through the tible below. Then use
the accompanying diagrams and procedures on the following pages to set up your
DVD-VCR.
lf your TV has audio/video inputs, refer to page 15 for audio/video (A/V) hook+
Then follow one of the hookups below. If your TV does not have A/V inputs, go
directly to one of the hookups below.
No cable box or
cable box with oniy a
few scrambled channels
/ Cable box with many scrambled
channels
After you have completed the connections, follow the instructions for setup.
After you have comple%ed the setup. you are ready to use your DVD-VCR
Procedures di%er depending on rhe hookup you used.
e Do not connect the AC power cords until all of the connections are completed. If
you connect the AC power cord before the connections are completed, you may not
be able co use the Plug and Play function.
e Be sure you make cortnections Ctnly. Loose connections may cause picture
dislortion.
0 If your TV does not match any of the examples provided, see your nearest Sony
dealer or
qualified
technician.
Connections between the DVD-VCR's VHF/UHF connector and
the antenna terminais of the
TV receiver
should bc
made only as shown in the following instructions.
Failure to do so may
result in operation that violates the regulations of the Federal Communications Commission
regarding rhe use and operation of RF devices. Never connect the output of
the DVD-VCR to an
antenna or make simultaneous (parable!) antenna and DVD-VCR connections at the antenna
teminals of your receiver.
cm2 to
v spt@.m ib%?&&?r (in
This reminder is provided to call the CATV system installer's attention to Article 820- 40 of the
NEC that provides guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the building, as close to the point of cable
entry as practical.
14 / Basic hook~~ps