Table of Contents
Advertisement
Setup Procedure
1. Determine the installation location
CAUTION
Installing your LCD display must be done by a qualified techni-
cian. Contact your dealer for more information.
CAUTION
MOVING OR INSTALLING THE LCD DISPLAY MUST BE DONE BY
TWO OR MORE PEOPLE. Failure to follow this caution may result
in injury if the LCD display falls.
CAUTION
Do not mount or operate the display upside down, face up or face
down.
IMPORTANT
Lay the protective sheet, which was wrapped around the LCD dis-
play when it was packaged, beneath the LCD display so as not to
scratch the panel.
2. Install the remote control batteries
The remote control is powered by 1.5V AA batteries. To install or
replace batteries:
1. Press and slide to open the cover.
2. Align the batteries according to the (+) and (–) indications
inside the case.
3. Replace the cover.
2
1
Remove the cover
Insert the batteries
CAUTION
Incorrect usage of batteries can result in leaks or bursting. JVC
recommends the following battery use:
•
Place "AA" size batteries matching the + and - signs on each
battery to the + and - signs of the battery compartment.
•
Do not mix battery brands.
•
Do not combine new and old batteries. This can cause a
shorten life or liquid leakage of batteries.
•
Remove dead batteries immediately to prevent battery acid
from leaking into the battery compartment. Don't touch ex-
posed battery acid, it cause damage to your skin.
NOTE: If you do not intend to use the Remote Control for a
long period, remove the batteries.
3. Connect external equipment
•
To protect the connected equipment, turn off the main power
before making connections.
•
Refer to your equipment user manual.
4. Connect the supplied power cord
•
The equipment should be installed close to a power outlet and
should be easily accessible.
•
Fully insert the prongs into the power outlet socket. Loose con-
nection may cause image degradation.
•
Use a power supply cord that matches with the power supply
voltage of the AC power outlet being used.
5. Switch on the power of all the attached
external equipment
When connected with a computer, switch on the power of the
computer first.
6. Operate the attached external equipment
Display the signal on the external equipment you wish.
7. Adjust the sound
Make adjustments when adjustment of the volume is required.
8. Adjust the screen (See pages 19-27)
Make adjustments when adjustment of the screen display
position.
9. Adjust the image (See page 19-27)
Make adjustments when picture adjustment such as the backlight
or contrast is required.
10. When display is installed in the portrait
position
•
Remove the stand (feet).
•
Left edge should be upper from front view.
11. When installing the display to a wall
3
Replace the cover
How to remove the stand
1.
Spread the protective sheet on the flat surface, such as
a desk.
2.
Place display on the protective sheet.
3.
Remove 2 screws by screwdriver and place them in a safe
place for reuse.
How to install stand
1.
Please turn display off.
2.
Insert claws of display to stand holes until clicks.
3.
Fasten 2 screws on both sides of the display.
Upper M5 x 55mm
Torque 280 - 300N•cm.
(See page 10-16)
English-9
Lower M5 x 45mm
Advertisement
Table of Contents
