Table of Contents
Advertisement
Troubleshooting
No picture
•
The signal cable should be completely connected to the display card/computer.
•
The display card should be completely seated in its slot.
•
Front Power Switch and computer power switch should be in the ON position.
•
Check to make sure that a supported mode has been selected on the display card or system being used. (Please consult display card or
system manual to change graphics mode.)
•
Check the display and your display card with respect to compatibility and recommended settings.
•
Check the signal cable connector for bent or pushed-in pins.
Power Button does not respond
•
Unplug the power cord of the display from the AC outlet to turn off and reset the display.
Image persistence
•
Please be aware that LCD Technology may experience a phenomena known as Image Persistence. Image Persistence occurs when a
residual or "ghost" image of a previous image remains visible on the screen. Unlike CRT monitors, LCD displays' image persistence is
not permanent, but constant images being displayed for a long period of time should be avoided.
To alleviate image persistence, turn off the display for as long as the previous image was displayed. For example, if an image was
on the display for one hour and a residual image remains, the display should be turned off for one hour to erase the image.
As with all personal display devices, JVC recommends displaying moving images and using a moving screen saver at regular
intervals whenever the screen is idle or turning off the display when not in use.
Image is unstable, unfocused or swimming is apparent
•
Signal cable should be completely attached to the computer.
•
Use the OSD screen controls to focus and adjust display by increasing or decreasing the clock phase total. When the display mode is
changed, the OSD Image Adjust settings may need to be readjusted.
•
Check the display and your display card with respect to compatibility and recommended signal timings.
•
If your text is garbled, change the video mode to non-interlace and use 60Hz refresh rate.
Image of component signal is greenish
•
Check to see if the DVD/HD input connector is selected.
LED on display is not lit (no green or red color can be seen)
•
Power Switch should be in the ON position and power cord should be connected.
•
Make certain the computer is not in a power-saving mode (touch the keyboard or mouse).
Display image is not sized properly
•
Use the OSD screen controls to increase or decrease the clock total.
•
Check to make sure that a supported mode has been selected on the display card or system being used. (Please consult display card or
system manual to change graphics mode.)
Selected resolution is not displayed properly
•
Use OSD information to enter Information menu and confirm that the appropriate resolution has been selected. If not, select correspond-
ing option.
No Sound
•
Check to see if speaker cable is properly connected.
•
Check to see if muting is activated.
•
Check to see if volume is set at minimum.
Remote Control is not available
•
Test the Remote Control's batteries for strength/life.
•
Check if the batteries are inserted correctly.
•
Check if the Remote Control is pointed at the display's remote sensor.
Either light vertical or horizontal stripes may appear, depending on specific display patterns.
This is no product fault or degradation.
English-30
Advertisement
Table of Contents
