Ipv4 Interface - D-Link DVA-5582 User Manual

Section 3 - Configuration
Select Yes to enable NAT (Network Address Translation) or No
Enable NAT:
to disable. NAT is a form of firewall and enabling it is strongly
recommended. The default is Yes.
Select Yes to enable DHCP and get and IP address automatically. If
Obtain IPv4
Address you have a fixed IP from your ISP or network administrator, select
No. If you select No, you will be prompted to enter an IP address
Automatically:
and a subnet mask.
IPv4 Address If you use a static IP address, enter it here. This field will only appear
if Obtain IPv4 Address Automatically is No.
Subnet Mask: If you use a stat IP address, enter the subnet mask here. This field will
only appear if Obtain IPv4 Address Automatically is No.
Setup as Default Select Yes to set this connection as the default source for your
Internet connection. Selecting No will require manual connection
Route:
in advanced settings. The default setting is Yes.
Setup Static DNS Select No to get DNS information automatically from DHCP. Select
Servers: Yes to setup DNS manually, and you will be prompted for a preferred
and alternate server.
Preferred DNS Enter the IP address of your preferred DNS Server. This field only
Server: appears if Setup Static DNS Servers is set to Yes.
Alternate DNS
Enter the IP address of your alternate DNS server. This field only
Server appears if Setup Static DNS Servers is set to Yes.
Click Next to configure IPv6 interface settings documented on the following page.
Click Cancel to return to the homescreen, or Back to return to the previous screen.
D-Link DVA-5582 User Manual

IPv4 Interface

DNS Configuration
24