Pure Bridge - D-Link DVA-5582 User Manual

Section 3 - Configuration
Pure Bridge mode disables the local DHCP server, causing your ISP to assign IP
addresses directly to any affected bridges. By default, the assigned bridge is all
Ethernet and Wi-Fi LAN clients.
Note: This feature may disable firewall features designed to help your network
resist intrusions and is not recommended unless specifically required by your ISP or
network administrator.
Note: Once Pure Bridge Mode in enabled, you will no longer be able to access the
configuration interface. Once enabled, the only way to make changes is to perform a
manual factory reset by pressing and holding the reset button on the back of router.
See Rear View on page 6 to find your reset button.
Bridge to LAN: Select a network bridge from the list. By default, Bridge1 includes all
Ethernet LAN and Wi-Fi interfaces. If you wish to configure additional
bridges, they must be set first from Bridge and VLAN on page 35
before continuing the Wizard.
Click Next to proceed to the Phase 1 Settings Summary on page 26.
Click Cancel to return to the homescreen, or Back to return to the previous screen.
D-Link DVA-5582 User Manual

Pure Bridge

20