Engine Oil; Oil Filter - Honda Goldwing GL1100 Aspencade 1982 Owner's Manual

2. Insert a new oil filter element. Check
that the O-rings (2) are in good condition
and that all parts·are installed as shown.
3. Install the oil filter cover and tighten
the oil filter bolt.
Oil Filter Bolt Torque:
27-33 N·m (2.7-3.3 kg-m, 20-24
ft-lb).
4. Perform steps 4 to 6 of Engine Oil
Change.
73
(2) O-rings (I) Filler clement
4. Fill the crankcase with approximately
3.2
liters
(3.4 U.S. quarts) of the recom-
mended grade oil and install the oil filler
cap.
5. Start the engine and let it idle for a
few minutes.
6. Stop the engine. Make sure the oil
level
is
at the upper level mark and
there are no oil leaks.
NOTE:
*
When running in very dusty conditions,
oil changes should be performed more
frequently than specified in the main-
tenance schedUle.
OIL FILTER
NOTE:
*
Change - the oil filter after draining
engine oil.
I.
Remove the oil filter bolt and pull
the oil filter element (I) out' o[ the.
oil filter
l:OVer.
1. To drain the oil, remove the oil filler
cap
(I),
drain plug (2), oil filter bolt
(3) and c.over (4).
2. Check that the sealing washer on the
drain plug is in good condition, and
install the plug.
3. Check that the oil filter bolt and cover
a-rings are in good condition, and
install the cover. aligning the recess in
the filter cover with the boss on the
water pump cover.
~~~
.....
---,...-:---"""":7.'"~
. .......- ......
7
(2) Drain plug (4) Filter cover
(3) Oil filter bolt
72
(I)Oilfillercap
ENGINE OIL
Engine oil quality is the chief factor
affecting engine service life. Change the
engine oil when specified by the maiote·
nance schedule.
NOTE:
*
Change engine oil with the engine
warm and the motorcycle on its center
stand to assure complete and rapid
draining.