Maintenance - Honda Goldwing GL1100 Aspencade 1982 Owner's Manual

l'iM;!}ii}iH
.. Do not pry the clips open to get a fuse
out: you could bend them and cause
poor contact with the new fuse. A
loose fuse could cause damage to the
electrical system and even start a fire.
REMOVAL.
®
)t
<'IJ~
,
®
(I)
Fuse holder (B) Remove
(A) Slide
66
To replace the main fuse (3), loosen the
screws and remove the old fuse. Install the
new fuse and tighten the screws securely.
To replace fuses in the fuse box (I), remove
the fuse box cover. Pull the old fuse out of
the clips; or slide it lengthwise until one
end comes out, then lift it out with your
fingers. Push a new fuse into the clips and
install the fuse box cover.
INSTALLATION
A
.~
$~cb
(1)
Fuse holder
.
-
MAINTENANCE - - - - - - - - - -
• The
u.s.
Environmental Protection Agency requires manufacturers to certify that
motor~cles built after December 31, 1977 wiD comply with applicable. emissions
standards during their useful life, when operated and maintained accordmg to the
instructions provided. Compliance with the terms of the Distributor's Warranty for
Honda Motorcycle Emission Control Systems is necessary in order to keep the emis-
sions system warranty in effect (USA ONLY).
• When service is required, remember that your authorized Honda dealer knows your
motorcycle best and is fully equipped to maintain and repair it.
The scheduled maintenance may also be performed by a qualified service facility that
normally does this kind of work; or you may perform most of the work yourself if you
are mechanically qualified and have the proper tools and service data.
• These instructions are based on the assumption that the motorcycle will be used ex-
clusively for its designed purpose. Sustained high speed operation, or operation in
unusually wet or dusty conditions
will
require more frequent service than specified in
the MAINTENANCE SCHEDULE. Consult your authorized Honda dealer for recommen-
dations applicable to your individual needs and use.
67