Honda Goldwing GL1100 Aspencade 1982 Owner's Manual page 19

Theft prevention:
This radio is mounted so that the main
radio unit and control unit are separate.
If you intend to leave your motorcycle
for a Jong period of time, the control
unit can be detached and taken with you.
Detaching the control unit:
1. Insert the ignition key (11) into the
lock and turn it clockwise.
2. While holding the key, pull it firmly
toward you. Once the unit is about
one-third withdrawn, pull it up and
detach it from the fairing.
3. Attach the blind panel (12).
Mounting the control unit:
1. Remove the blind panel by pulling its
lower end.
2. Insert the two tabs on the bottom of
the control unit into the groove in the
holder~
3. Push the unit until you hear the lock
click.
4. Check that the unit is locked into
position.
30
(11) IgnJtion key
(12) Blind panel
Fuse replacement:
The fuse holders for motorcycle radio are
located inside the left turn signal lamp.
Remove the turn signal lens and the fuse
holder band. The specified fuses are:
Main power supply: '2A
Back up power supply: 1A
Booster amplifier: SA
When frequent fuse failure occws, it
usually indicates a short circuit or an
overload in the electrical system. In this
case, the electrical system should be
checked visually for damaged insulation
or other possible faults. If the problem
cannot be located visually, the motorcycle
should be examined by an authorized
Honda dealer.
I?JW'i1fild&
• Never use a fuse with a different rating
from that specified. Serious damage
to the electrical system or a fire may
result.
(13) Fuse holders
31
4