Brother HL-L8260CDN Online User's Manual page 265

Error Message
Cover is Open
Cover is Open
Drum !
Drum Stop
Jam 2-sided
Jam Inside
Jam MP Tray
Jam Rear
Jam Tray
Jam Tray1
Jam Tray2
Jam Tray3
Jam Tray4
Limit Exceeded
Media Type Mismatch
No Belt Unit
No Drum Unit
No HUB Support
Cause
The front cover is not completely
closed.
The fuser cover is not completely
closed.
The corona wires on the drum unit
must be cleaned.
The drum unit or the toner
cartridge and drum unit assembly
is not installed correctly.
It is time to replace the drum unit.
The paper is jammed underneath
the paper tray or the fuser unit.
The paper is jammed inside the
machine.
The paper is jammed in the MP
tray.
The paper is jammed in the back
of the machine.
The paper is jammed in the
indicated paper tray.
The print limit set in Secure
Function Lock 3.0 was reached.
The media type specified in the
printer driver differs from the
paper type specified in the
machine's menu.
The belt unit is not installed or not
installed correctly.
The drum unit is not installed
correctly.
A USB hub device is connected to
the USB host connector.
Action
Open and then firmly close the front cover of
the machine.
Close the fuser cover located inside the back
cover of the machine.
Clean the corona wires on the drum unit.
See Related Information: Clean the Corona
Wires.
If the problem continues, replace the drum unit
with a new one.
Remove the drum unit, remove the toner
cartridges from the drum unit, and put the
toner cartridges back into the drum unit.
Reinstall the drum unit in the machine.
Replace the drum unit.
Remove the paper tray or open the back cover
to pull out all jammed paper.
Open the front cover, remove the toner
cartridges and drum unit assembly, and pull
out all jammed paper. Close the front cover.
Remove all jammed paper from in and around
the MP tray. Press Retry.
Open the fuser cover and remove all jammed
paper. Close the fuser cover. If the error
message remains, press Start
Pull out the paper tray and remove all jammed
paper as shown in the animation on the LCD.
Call your administrator to check your Secure
Function Lock Settings.
Load the correct type of paper in the tray
indicated on the LCD, and then select the
correct media type in the Paper Type setting
on the machine.
Reinstall the belt unit.
Reinstall the toner cartridges and drum unit
assembly.
Disconnect the USB hub device from the USB
host connector.
260