Kurzweil FORTE SE Musician's Manual page 81

Program Edit Mode
The Parameters (PARAMS) Page
Important note about selecting a Control source
When you change the control source for a parameter, the new control source immediately sets its
current value for the MIDI value of the current parameter. If the MIDI value of the parameter
was set to None before changing the control source, changing the control source will set a new
MIDI value, but the Value column for the parameter will still display None (see Important note
about values of "None"). This can be troublesome if for example you were to change the Control
Source for the Expression parameter, you may accidentally set the MIDI Value to 0, but wouldn't
know it because None would still be displayed. Also, if you set a MIDI Value to None by scrolling
below 0, the MIDI value will be 0 until you change the value with the assigned controller
(though None will still be displayed). If you edit the parameters of a program and suddenly can't
produce any sound from the program, this may be the cause. In this case, either set the Value for
Expression to something other than None, or use the Control Source that you set for Expression
to increase the Value.
Value
The Value (right) column sets the initial MIDI value that the Parameter in the selected row
and it's assigned controller will have when the Program is selected. This value changes as you
move the assigned controller, so don't move the assigned controller if you have set a value
that you wish to save. To set a specific value, use the cursor button to highlight the right
column and type a value followed by the Enter button (or select a value of None by typing
-1, followed by the Enter button). You can also use the Alpha Wheel or Value buttons to
enter a MIDI value from 0-127, or a value of None by scrolling below 0. If you set a Value
to None by scrolling below 0, the value will be 0 until you change the value with an assigned
controller (though None will still be displayed).
7-12