Kurzweil FORTE SE Musician's Manual page 18

Switch Pedals
Continuous Control
(CC) Pedals
The default function of each pedal can be changed for all Programs and Multis by setting
a pedal override on the Global Control Overrides page in Global Mode. Pedals are also
independently assignable within each Program or each Zone of every Multi.
Here are the default control settings for the five pedals used by Forte SE:
SW 1a Pedal
SW 1b Pedal
SW 2a Pedal
SW 2b Pedal
CC Pedal
The SW1 (Sustain) and SW2 Jacks
Use the pedal jacks to connect switch pedals. A switch pedal is a physical controller typically
used to control two-state (i.e., "on / off") parameters, such as sustain, sostenuto, soft and
Mute Zone.
1/4 inch tip-sleeve (mono) plug or, 1/4 inch tip-ring-sleeve plug
configured as dual switches (TS and RS) or 2 terminal continuous pedal
(half-damper).
10 kΩ linear-taper potentiometer, 1/4 inch tip-ring-sleeve (stereo) plug
with the wiper connected to the tip.
Sustain (MIDI 64)
Sostenuto (MIDI 66)
Sostenuto (MIDI 66)
Soft (MIDI 67)
Expression (MIDI 11)
Getting Started
The Pedal Jacks
2-5