Zone Parameters - Kurzweil FORTE SE Musician's Manual

Multi Edit Mode

Zone Parameters

On the Multi CCs or Multi Switches page, when the Entry Pos, Exit Value, OnValue,
or OffValue parameter is selected, you can change the value of the selected parameter by
holding Enter and moving any Controller or Switch.
Enter + Key
In Multi Edit Mode, on the Overview page, with the Low Key Range or High Key Range
parameter selected, hold the Enter button and strike a key to set the Low Key or High Key.
On the Multi Switches page, when Mode = Chord and one of the Key1-8 parameters is
selected, hold the Enter button and strike a key to set a key value.
Zone Parameters
Each of the available Zones in a Multi has multiple parameters that determine its behavior.
Since the Zones of a Multi are independent of each other, changing a parameter for a certain
Zone will not affect the parameters of any other Zone. There are some exceptions to this,
for example, the parameters on the Common Page are common to all available Zones. Also,
on the Controllers Page for Switch Controllers, the parameters Type, Entry State, and Exit
State are common to all available Zones. Lastly, on the Controllers Page for Continuous
Controllers, the parameters Entry Position and Exit Value are common to all available Zones.
The top right corner of the display of the each page shows the currently selected Zone out of
the available Zones, or "All Zones" if the parameter applies to all Zones.
Also, on the Multi CCs Page, the parameters Entry Position and Exit Value are common to
all available Zones. Lastly, on the Multi Switches Page, the parameters Type, Entry State and
Exit State are common to all available Zones.
11-4