Kurzweil FORTE SE Musician's Manual page 251

Mode
The Mode parameter determines whether the Multi will use its own Audio Input settings, or
whether it will use the Audio Input settings set in Global Mode.
By default, Mode is set to "Use Global Mode Effects", which means the Multi will use the
Audio Input settings set on the Global Mode Audio Input page (for details see
(Audio Input Page) on page
Mode Audio Input page will display "(No aux)".
Set Mode to "Multi Specific Effects" to enable Audio input effects for the current Multi.
When "Multi Specific Effects" is selected, the Chain, Control Ch and MODs parameters will
appear.
Chain
When the Audio Input Mode parameter is set to "Multi Specific Effects", you can use the
Chain parameter to select an FX chain to apply to the rear panel 1/8" (3.5mm) input signal.
If you wish to edit a Chain, you can enter the Chain Editor by pressing the Edit button (see
Ch. 8 The Effects Chain Editor, on page 8-1
Note the "0/0 Units" in the middle of the top line of the page. The left-hand number is the
size of the Chain, and the right-hand number is the total number of units that the Multi is
attempting to use. A Multi can use a maximum of 32 FX units. If you exceed the maximum
number of DSP units, "(max 32)" will appear to remind you of the maximum.
When selecting an Audio Input Chain, the Chain may steal FX unit resources from other
channels in order to load. Because of this you may see some Channels on the FX page
become set to (Y) (higher numbered channels will be stolen first).
Control Channel (Control Ch)
Use the Control Ch parameter to set the MIDI channel on which you wish to control Chain
Mods. See Channel on page 11-8
section below for more details on Effect Chain Mods.
MODs
Effect Chain Mods are modulation controls which can be assigned to the Forte SE's physical
controllers. Any Mods assigned within the selected Audio Input Chain can be controlled by
controllers assigned within the Multi.
The MODs field displays any MIDI CC numbers which have been assigned to control FX
Chain Mods within the selected Audio Input Chain. To view which parameters these CC
numbers are assigned to, select the Chain field and press the Edit button to enter the Chain
Editor, then go to the Chain Info page (see
8-1 for details).
12-23). If no FX Chain is selected in Global Mode, the Multi
for details).
for details on Multi Zone MIDI Channels. See the MODs
Ch. 8 The Effects Chain Editor, on page
Multi Edit Mode
Audio Input (AUD-IN)
AUD-IN
11-33